Saving Data - Rohde & Schwarz R&S RTO2000 Series Getting Started

®
R&S RTO2000
To save screenshots
1. Press the
2. Change the horizontal scale.
3. Press the
The files are saved to the following directory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
ScreenShots
The default file name is Screenshot_<date>_<index>_<time>.png.
4. To access the saved files, open the "File" menu and tap "Minimize Application".
5. Double-tap the "User" folder icon on the desktop.
6. Open the ScreenShots folder.

4.13 Saving Data

After a measurement with the R&S RTO, you can save the resulting waveform data for
further evaluation or comparison. You can also save measurement results, and device
settings to repeat or restore previous measurements.
●
"Saving waveform data"
●
"Saving data of an acquisition series"
●
"Saving measurement results"
●
"Saving and restoring device settings"
Saving waveform data
1. Press the [Save Recall] key on the front panel (in the Setup area on the left).
2. Select "Waveform".
3. Check the "Source".
4. Set "Scope" to "Full Waveform".
Tip: If a cursor, zoom or measurement gate is defined, you can use these settings
to export only a part of the waveform.
5. Under "Save to file", tap "Save As".
6. The file selection dialog box shows the default storage directory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
RefWaveforms
7. Tap the keyboard icon on the right of the "File Name" field.
Getting Started 1332.9719.02 ─ 08
key.
key.
on page 69
on page 70
Trying Out the Instrument
on page 70
on page 71

Saving Data

69