Epson WF-C579R Start Here page 2

3
Install ink supply units
(ink packs)
Note:
• The product is designed for use with Epson ink packs only, not
third-party ink.
• The ink packs included with the product are designed for product
setup and not for resale.
• After some ink is used for charging, the rest is available for printing.
Caution: Keep the ink packs out of the reach of children and do not
drink the ink.
1
Unlock and open the ink pack tray cover.
2
Press an ink pack tray to release it, then pull the tray out.
3
Remove and discard the protective piece from the ink
pack tray.
4
Shake an ink pack 10 times, then remove it from the
packaging.
Do not touch the green chip on the ink pack.
Note:
5
Place the ink pack into the ink pack tray, move the
handle forward, then move the handle back to its original
position.
Make sure the ink pack is fully inserted and level with the
Note:
top of the ink pack tray.
6
Insert the ink pack tray into the printer. Repeat steps 2 to
6 for the other ink packs.
The ink packs are keyed to fit into the correct color slot.
Note:
If you cannot insert the ink pack tray all the way, do not force
it. Make sure the ink pack color matches the color slot on the
printer.
7
Close the ink pack tray cover and lock it.
8
Select OK on the LCD screen to start charging the ink.
Ink charging takes approximately 9 minutes. A message
appears when ink charging is complete.
Don't turn off the product, raise the scanner unit,
Caution:
or open the front cover while the product is charging or you'll
waste ink.
4
Load paper
For instructions on loading envelopes or legal-size paper, or
using the rear paper feed slot, see the online User's Guide.
1
Make sure the product is done charging the ink, then pull
out one of the paper cassettes.