Selecting Units To Monitor/Configure - Fairford agility Series User Manual

If any of the Modbus communication parameters are dissimilar on the host unit or remote
keypad, communication will not be established. The keypad will display the following screen:
By pressing the Right key, the user will be taken directly to the Modbus address selection menu:
If the selected Modbus address is valid, the status screen is displayed:

Selecting Units To Monitor/Configure

When the Remote Keypad is attached to multiple agility
can switch between each unit by using the following method.
To simplify this selection process it is recommended that the host agility
with consecutive Modbus addresses
(continued over)
agility TM Series Soft Start User Manual
MAN-AGY-001. Version 04. 21/09/2018
May show: Local, Remote or Modbus
Press CENTRE key
TM units on the Modbus network, the user
121
Only Right key is active
Use UP / DOWN
keys to select
address.
Press centre to
confirm
units are configured
TM