Metrohm 945 Professional Detector Vario – Conductivity & Amperometry Manual page 21

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1
945 Professional Detector Vario – Conductivity & Amperometry (2.945.0030)
Mounting the bottle holder
Before you can mount the bottle holder, the following preconditions must
be met:
The instrument is switched off.
￭
To mount the bottle holder, you need a 3 mm hex key (6.2621.100).
2
1 Place the bottle holder onto the topmost instrument in such a way
that the openings in the bottle holder exactly match the screw
threads on the top surface of the instrument.
2 Insert the two cylinder screws and tighten them with the 3 mm hex
key.
3 Insert both covering stoppers.
After attaching the bottle holder, all connections that were undone at the
beginning of the process must be reconnected.
Restoring the loosened connections
1 Plug in all necessary USB cables.
2 Plug in all necessary MSB cables.
3 Plug in the power supply cable.
4 Mount the drainage tubing again (see manual of the IC instrument).
3 Installation
3
￭￭￭￭￭￭￭￭
13