Guideline: Ufm Content Initialization; Guideline: Erase Before Program - Altera MAX 10 User Manual

3-2

Guideline: UFM Content Initialization

The JTAG interface supports Jam
( ), Programmer Object File (
.jam
You can use the Quartus Prime Programmer to program
program
.pof
1. In the Programmer window, click Hardware Setup, and select USB Blaster.
2. In the Mode list, select JTAG.
3. Click Auto Detect on the left pane.
4. Select the device to be programmed, and click Add File.
5. Select the
6. Select the UFM in the Program/Configure column.
7. Click Start to start programming.
To program through
Device Programming application note.
Related Information
AN 425: Using the Command-Line Jam STAPL Solution for Device Programming
Guideline: UFM Content Initialization
You can initialize the UFM content using Altera software.
The initial memory content supports Memory Initialization File (
File ( ).
.hex
You can initialize the UFM content using either one of the following ways:
• Set the initial memory content through the Altera On-Chip Flash IP core.
• Set the initial memory content through the Convert Programming File tool in the Quartus Prime
software when you convert

Guideline: Erase Before Program

Make sure to erase the flash location before you perform a program (write) operation.
Altera Corporation
Standard Test and Programming Language (STAPL) Format File
™
), and JAM Byte Code File (
.pof
, into the flash, follow these steps:
to be programmed to the selected device.
.pof
or files, refer to the Using the Command-Line Jam STAPL Solution for
.jam .jbc
to
.sof
.pof
.
.pof
).
.jbc
through the JTAG interface. To
), and Hexadecimal (Intel-Format)
.mif
MAX 10 UFM Design Considerations
UG-M10UFM
2016.05.02
Send Feedback