OFM Mesa Series Assembly Instructions

Model 66360
Parts Listing
A
Desk Top
1 Unit
B C
Side Panel Legs Pedestal
2 Units
2 Units
D E F
Privacy Panel Drawer Runners Center Drawer
1 Unit 2 Units 1 Unit
G H I
6x55mm Screw 10x35mm Screw 6x16mm Screw
8 Units 4 Units 12 Units
L
J K
Allen Wrench Phillips Head Corner
1 Unit Screw Bit Leg Bracket
1 Unit 4 Units
Mesa Series Double Pedestal Teacher's Desk
1
B
L
H
J
A
E
E
I
3
I
C
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly. Assembly will require 2 people.
Step 1: Align Side Panel Legs (B) with the support rail on the underside of the Desk Top (A).
Place Corner Leg Bracket (L) in holes on support rail, and insert 10x35mm Screw (H)
through bracket and into legs. Tighten using Allen Wrench (J). Align Drawer
Runners (E) with holes in underside of the Desk Top (A). Attach using 6x16mm
Screws (I) and Phillips Head Screw Bit (K).
Step 2: Attach Pedestals (C) to underside of Desk Top (A) by aligning screw holes in
Pedestals with holes in Desk Top, and inserting 6x55mm Screws (G) to secure.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
Step 3: Attach Pedestals (C) to Side Panel Legs (B) by inserting
2
G
B
Step 4: Attach Privacy Panel (D) to Pedestals (C) by inserting 6x16mm
C
Step 5: Flip the desk right side up using at least two people. Insert the
A
4 5
I
K
D
C
01.13.2014
6x16mm Screws (I) through pedestal wall and into legs.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
Screws (I) through sides of Pedestals (C) and into side of
Privacy Panel (D).
Center Drawer (F) backwards, as shown, aligning it with the
Drawer Runners (E). Push Center Drawer (F) all the way in to
secure.
F
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com