Advertisement

THANK YOU FOR VOTING TEXECOM
THANK YOU FOR VOTING TEXECOM
THANK YOU FOR VOTING TEXECOM
THANK YOU FOR VOTING TEXECOM
Remote Keypad
I N S T A L L A T I O N M A N U A L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Veritas RKP and is the answer not in the manual?

Questions and answers

Summary of Contents for Texecom Veritas RKP

  • Page 1 THANK YOU FOR VOTING TEXECOM THANK YOU FOR VOTING TEXECOM THANK YOU FOR VOTING TEXECOM THANK YOU FOR VOTING TEXECOM Remote Keypad I N S T A L L A T I O N M A N U A L...
  • Page 2 1 INSTALLATION The Veritas Remote Keypad (RKP) is suitable for use with the Veritas range of Control Panels. 1. Up to 6 keypads may be used in total. 2. The Unset LED on the keypad will flash during entry or to indicate a power fault. 1.1 Mounting Open the keypad by carefully inserting a small flat-blade screwdriver into either half of the double slot at the base of...
  • Page 3 Connect the keypad to the control panel using 4-core cable as follows: Keypad Control Panel AUX+ AUX- Please see Figure 1 on back page. Up to six keypads may be connected in parallel (“star”) or series (“daisy-chain”) or any combination. 1.
  • Page 4 Address DIP 1 DIP 2 DIP 3 DIP 4 1. NEVER set two RKPs to the same address. 2. Keypads are factory set to address 1. 3. If the keypad is powered but offline (i.e. T and R not connected) the zone LED corresponding to the address currently selected will light.
  • Page 5 From the unset state: !!!! 1. Enter your Engineer Code " 2. Press PROG to access the Programming Menu 3. Enter 09 to select the Configure RKPs option " 4. Press PROG, the system will chime & scan for RKP addresses 1 - 6 5.
  • Page 6 2 TECHNICAL SPECIFICATION 2.1 Electrical Operating Voltage Nominal: 13.7V Minimum: 10.0V <70mA Current Consumption: Volume: Dual Level Back-Light: 600mcd typical 4-Core, ≤100m Cable: Connection: Serial, Parallel or any combination 1.2 Environmental Operating Temperature: –10°C (+14°F) to +50°C(+122°F) Storage Temperature: –20°C (–4°F) to +60°C(+140°F) Maximum Humidity: 95% non-condensing EMC Environment:...
  • Page 7 (details on request). As the Veritas RKP is not a complete alarm system but only a part thereof, Texecom cannot accept responsibility or liability for any damages whatsoever based on a claim that the Veritas RKP failed to function correctly.

Table of Contents