Connector Cap Removal; Connecting Sdi - Nokia OZO Manual

Connector Cap Removal

For streaming data through SDI and
supplying external power, remove
the connector cap (A) located below
the "tail" section by using the
provided T6 Torx tool.
For stand alone use, place the
connector cap back in the slot and
tighten by hand without excessive
torque.
This cap provides basic sealing and
protection for the SDI and power
connectors.

Connecting SDI

18
Attaching 3G-SDI card
Carefully remove the 3G-SDI SFP+
(A)
card from the ESD bag, and insert
it firmly into the SFP+ socket (B).
To remove, lift the latch
card and carefully apply backwards
A
pressure to the frame of card, NOT to
the DIN sockets.
Attaching SDI DIN cable
Attach a standard SDI DIN connector
(D) to the lower DIN socket shown by
arrow facing away from device.
To remove the cable, lift the cover
of the DIN connector, and apply
pressure.
Take care not to apply lateral force to
the DIN sockets. Use cable strain relief
where necessary, otherwise damage
may occur.
(C) on the SDI
B
A
C
19
D