HPE Moonshot 1500 Maintenance And Service Manual page 31

2. Install the chassis into the J-slot on the rails, and then pull it forward.
3. Push in the release lever, and then install the chassis into the rack.
CAUTION: Press and hold the "Push" tab on each rail until the chassis begins to slide into the rack.
Then, release the "Push" tabs and continue to slide the chassis into the rack. Press and hold the
"Push" tab on each rail again when the rails lock at a 76.2-cm (30-inch) extension. Then, release the
"Push" tabs again and finish sliding the chassis into the rack. Failure to release the "Push" tabs may
cause damage to the rails.
Removal and replacement procedures 31