Craftsman 247.240800 Operator's Manual page 10

Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place on the tractor,
follow these steps to assemble the remaining bagger components.
1. Snap the plastic upper chute support in place by first clipping the side
portion onto the bagger support rail (1) with the edge of the snap feature
aligned with the red line, as shown in the inset of Figure 7.
2
2. Snap the front side of the chute support to the rail (2), as shown in Figure 7.
3. If not previously installed by the factory, install the bagger screen into the
bagger cover by first inserting the end closest to the center into the cutout
mounting hole, as in Figure 8. Make sure to feed the screen under the lip, as
in Figure 9.
ASSEMBLY AND INSTALLATION
1
Figure 7
Figure 8
4. Clip in the other side by flexing the screen and pushing it down into the
provided cutout hole. See Figure 9.
Make sure screen sits under the cover's lip
5. Install the bagger cover onto the bag support assembly, as shown in Figure
10. The plastic cover goes inside of the two mounting tabs.
Cover mounts in
between these
two tabs
10
Figure 9
Figure 10