Advertisement
Using the device
Status
Action
Alert detection
Fall alert
deactivation
Updating
Configuration
For information on
how to use the
notification
buttons, see
Notification button
chapter
Notification
Button", Page 16
The device takes approx. 30 seconds to start after the power is turned on. Do not press any
buttons at this time
Flash = every 0.5 seconds
Long Flash =every 1 second
14
Displays
300 long red
－
Press the power
Alarm is turned
button for 1
second
Stays lit Orange
－
Flashes orange
"
3 long orang
Description
flashes
Fall / fall over alert detected
(approx.. 5
mins)
10 long red
All other alert notification detected
flashes
When the power button is pressed for 1
second an alert notification of a fall
off
detection will be cancelled by sending a
cancellation message to the gateway
The configuration within the Vital
Sensing Unit S is being updated
The notification signal is being sent to the
3 times
gateway when the button(s) are pressed.
The notification signal was received by the
flashes
gateway when the button(s) were pressed.
Fujitsu
Advertisement
