Table of Contents
Advertisement
Tips and Troubleshooting
If your access point Power LED light is flashing orange and all other LEDs are off for over
10 minutes
The access point cannot connect to the KodaCloud management services. This usually occurs
when the unit cannot get an IP address from your network using DHCP and has switched to
Local Network Configuration mode.
While in this mode, the access point does not pass data through the LAN1 port and broadcasts
an SSID that contains a portion of the access point's MAC address. You can use any Wi-Fi
enabled device to connect to this SSID and configure the network settings for this access point
using a web browser.
To connect to the access point using the Local Network Configuration interface:
1.
Connect your Wi-Fi enabled device to the SSID in the form of "AP-XX:XX:XX" (where
X is a placeholder)). You are successfully connected when the Power LED on the
access point becomes solid red.
2.
Use your web browser to navigate to
password: admin).
3.
Follow the on-screen instructions
See the Support section (http://kodacloud.com/support) for information about Local Network
Configuration.
Note: Local Configuration mode only activates if the access point is in factory default
condition and has never connected to the KodaCloud management services in the cloud.
Learning More, Service, and Support
Online Resources
Our support website (http://kodacloud.com/support) contains links to online resources
available to help you get the most out of your access point.
Copyright and Trademark
Copyright © 2016 KodaCloud, Inc. All rights reserved. The contents of this Installation Guide
are the copyrighted and proprietary property of KodaCloud, Inc. Reproduction, distribution
or modification without the express, written permission of KodaCloud, Inc. is not permitted.
"Art2Wave" and "KodaCloud" are trademarks of KodaCloud, Inc. All other trademarks are the
property of their respective owners.
http://192.168.100.1
(login using user: admin,
Advertisement
Table of Contents
Need help?
Do you have a question about the OAP30 and is the answer not in the manual?
Questions and answers