Figure 41 Securing The Rear Connection Bracket And Input Idler - HP Indigo Division Series Instruction For Use & Installation Instructions

Figure 41 Securing the rear connection bracket and input idler

1 Rear connection bracket
2 Lower screw securing the rear connection
bracket
3 Turnbar rear wall
4 Turnbar input idler
5. Install the rear collar spacer (Figure 41).
6. Install two additional Allen M5 screw (P/N MBS-0840-10) to secure the rear connection
bracket (Figure 41).
NOTE:
7. Holding the turnbar in position, tighten the screws.
8. Connect the turnbar air hose to the turnbar air pressure air valve.
9. To connect the printing engines to each other:
a. Mount the front link bracket (Figure 37 and Figure 38).
Install the two 19 mm bolts and the two M6 Allen screws.
Do not tighten the joining M10 Allen screw yet. It remains loose for final adjustments.
b. Repeat step a above for the rear link bracket (Figure 37).
c. Check the horizontal alignment of the printing engines using the surveying tool.
Realign, if necessary.
Before tightening all the screws to secure the turnbar, make
sure that all of the turnbar rollers move without friction.
CA294-03070 rev 00
5 PE2 input idler
6 Collar spacer
7 Upper screw securing the idler
Installation Manual
page 56 of 153