Msu Assignment - Sony BVP-900 Series System Manual

6
Press [Status].
The display changes to the Security Status setting
display.
Security Status
Engineer Mode
Ref. Lens
Enable Enable
Engineer Mode
View
Full Lock
Mode
7
Set the statuses for control from the MSU-700A/
750.
[Ref. Enable]: Set it to inverse video to enable the
setting in the reference file (Factory setting:
ON).
[Lens Enable]: Set it to inverse video to enable the
setting in the lens files (Factory setting: ON).
[OHB Enable]: Set it to inverse video to enable the
setting in the OHB files (Factory setting: ON).
[Full Lock]: Set it to inverse video to fully disable
the MSU-700A/750 (Factory setting: OFF).
[View Mode]: Set it to inverse video to disable all
operations from the MSU-700A/750 other than
data reference (Factory setting: OFF). (Only the
display and indicators will be active. Any
settings and adjustments will be disabled.)
[Paint Only]: Set it to inverse video to enable paint
control only (Factory setting: OFF).
8
When the status settings are completed, press
[Exit].
The Security Menu display in step 5 is restored.
9
Press [Engineer Mode] to exit Engineer mode.
The statuses specified in step 7 become valid.
Note
All operations are enabled in Engineer mode
regardless of the above status settings.
Exit
OHB
Enable
Paint
Only

3-4-3 MSU Assignment

You can assign specific units among the cameras in the
same system to be selected/controlled from the MSU-
700A/750.
This MSU assignment is to be made, for example, to
assign cameras to each MSU-700A/750 when multiple
MSU-700A/750 units are used in the same system.
The assignment operation is enabled only in Engineer
mode.
Operation
Proceed as follows:
Configuration Menu
MODE
Configuration Menu
Camera CCU
MULTI
CNU MSU
1
CARD
CONFIG
MAINTENANCE
FILE
PAINT
1
Press to light the CONFIG button of the menu
control block to call the Configuration Menu on
the display.
2
Press [CNU].
The CNU Configuration Menu appears.
CNU Configuration menu
CNU Configuration
Engineer Mode
RCP MSU
Assign Assign
Note
The item [MSU Assign] is displayed only in
Engineer mode is active.
2
(Example: MSU-700A)
Exit
(Continued)
3-91
Chapter 3 Initial Settings