K'Nex Education 79100 User Manual page 28

K'NEX Robotics User's Guide
Deleting Flow Lines
If you make a mistake and wish to connect a line with a different symbol either:
• Use the Flow Line tool as if there wasn't already a line there, i.e. by placing a new
line from one symbol to another to automatically replace the old connection.
OR
• Select the line you wish to change and click on the Delete icon. Then select the flow
line symbol again and make the desired connection.
NOTE: If a flowchart is run and it reaches a symbol that does not have a flow line to dictate
where to go next, the flowchart will cease to run. Therefore it is important that all symbols
are connected.
This tool allows you to select an existing symbol in the edit area. Once selected it can be
moved, edited, deleted, etc.
NOTE: This tool will automatically deselect when Flow Line is selected.
To select a symbol
mputer:
To deselect
To select more
than one symbol
in the edit
area
Software:
To select part of
a flowchart
To move a symbol
To edit the
commands in
a symbol
To delete a symbol
or line
Education
education.com
The Symbols
Selection
Click on the symbol (it will highlight to show it is
selected).
Click in the blank space in the edit area.
ystem:
With Selection active, hold down the CTRL key
and click on each symbol.
Position the mouse pointer at the top corner of
the area to be selected. Click, hold down and
drag the rectangular box over the area to be se-
lected and release the mouse.
Click on the symbol (it will highlight to show it is
selected) and drag to a new position.
Click on the symbol (it will highlight to show it
is selected). Change your current choice in the
selection panel.
Click on the symbol or line (it will highlight to
show it is selected) and click on the Delete icon.
®
Education ®
Building Programs
SOFTWARE
28