Related Manuals for Openpath ACU-4W
Summary of Contents for Openpath ACU-4W
- Page 1 OPENPATH ACCESS CONTROL SYSTEM INSTALLATION GUIDE V1.2 Version 1.2 CONFIDENTIAL © Openpath 2018 ...
- Page 2 Openpath Access Control System Installation Guide GETTING STARTED ADDITIONAL RESOURCES PRIOR TO INSTALLATION Installation NETWORK REQUIREMENTS SELECTING A BACKUP BATTERY RECOMMENDED CONFIGURATION WIRING THE REX WITH THE DOOR STRIKE WIRING THE REX WITH THE ELECTROMAGNETIC LOCK ...
-
Page 3: Getting Started
PRIOR TO INSTALLATION Prior to installing Openpath hardware, it is assumed that you have performed a customer site survey and have determined the following: ● How many entries need to be configured (e.g. doors, gates, and/or elevator floors) ... -
Page 4: Recommended Configuration
SELECTING A BACKUP BATTERY While not required, Openpath recommends having a backup battery in the case of power outages. The size of battery depends on your setup and how long you want to power the system. Table 1: Power requirements (12V) ... - Page 5 Alternatively, the reader may also be surface mounted with the included back plate. NOTE: F or elevators, all relays must be on the same ACU. If you need more than four access controlled floors, use our elevator expansion board. Version 1.2 CONFIDENTIAL © Openpath 2018 ...
- Page 6 WIRING THE REX WITH THE DOOR STRIKE Version 1.2 CONFIDENTIAL © Openpath 2018 ...
- Page 7 WIRING THE REX WITH THE ELECTROMAGNETIC LOCK Version 1.2 CONFIDENTIAL © Openpath 2018 ...
- Page 8 Fail safe and fail secure are ways of configuring locking hardware: Fail safe hardware u nlocks when power is interrupted ● Fail secure hardware l ocks when power is interrupted ● Version 1.2 CONFIDENTIAL © Openpath 2018 ...
- Page 9 WIRING TO LEGACY PANELS To support a legacy access control system, install the ACU between the Openpath readers and the legacy panel, with the ACU Wiegand port configured as output to the legacy panel. Replace low frequency (LF) Wiegand readers with LF Openpath readers and high frequency (HF) Wiegand ...
-
Page 10: Troubleshooting
Sometimes legacy wiring (unshielded and straight through, rather than shielded twisted pair, often 22-6) used with reader results in slower connections and dropped packets between the Openpath Reader and Smart Hub. To remedy this, you can switch GND and VIN with +B and -A connections on ... - Page 11 WARNING: Only hard reset the ACU if absolutely necessary and if instructed by Openpath. This will clear all of the data off of the ACU and will require reprovisioning, which requires having a computer or mobile phone on the same network as the ACU. ...
- Page 12 5. Go to H ardware > A CU Management 6. Locate the ACU on the list and click R egister 7. A new window will open with instructions on registering the ACU. Click Y es to proceed. Version 1.2 CONFIDENTIAL © Openpath 2018 ...
Need help?
Do you have a question about the ACU-4W and is the answer not in the manual?
Questions and answers