Cisco Unified Communications Manager Phone
Setup
•
•
•
•
•
•
•
Set Up a Cisco IP Phone
If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must manually configure the Cisco IP Phone in Cisco Unified Communications Manager
Administration. Some tasks in this procedure are optional, depending on your system and user needs.
For more information on any of the steps, see the documentation for your particular Cisco Unified
Communications Manager release.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Procedure
Step 1
Gather the following information about the phone:
• Phone model
• MAC address: see
• Physical location of the phone
• Name or user ID of phone user
• Device pool
• Partition, calling search space, and location information
Set Up a Cisco IP Phone, on page 55
Determine the Phone MAC Address, on page 60
Phone Addition Methods, on page 60
Add Users to Cisco Unified Communications Manager, on page 61
Add a User to an End User Group, on page 63
Associate Phones with Users , on page 64
Surviveable Remote Site Telephony, on page 64
Determine the Phone MAC Address, on page 60
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
5
C H A P T E R
55