Dromida KODO FPV User Manual

READ THESE READ THESE
INSTRUCTIONS INSTRUCTIONS
BEFORE BEFORE FLYING !
Controller
Flight Battery
CONTROLLER
Phone Holder
Picture Throttle
Button Trim
Throttle/Rudder
Rudder ON/OFF Aileron
Stick Trim
CHARGING the FLIGHT BATTERY
Plug charger into USB port or AC adapter (DIDP1125 not included)
as shown and connect the battery. The red LED will flash slowly
while the battery is charging. The LED will be steady when the
battery is fully charged.
• NEVER leave the battery unattended while charging.
• DO NOT allow the USB port to power down while the charger
is connected to the battery.
• ALWAYS unplug the charger from the USB port and the
battery when charging is complete.
• The battery connector will only fit in one way.
FLYING !
Spare Blades
(2 black, 2 red)
KODO ™ Drone
Elevator Video
Trim Button
Remove the screw on
the battery compartment
cover. Take the cover off
and insert 4 AAA batteries.
Replace cover, securing
Aileron/Elevator
Trim Stick with the screw.
SETUP
Your KODO FPV comes with a Power-On Fail-Safe. This ensures that
the motors will not start until the KODO has detected the controller.
The KODO FPV's motors are now armed and the quad is ready to
fl y. The red LED on the KODO FPV will become steady.
FPV Headset
4 AAA Batteries
SENSITIVITY ADJUSTMENT
Push down on the left stick to
Lowest (Default)
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or
rechargeable batteries.
1. Turn on the controller with the throttle
at its lowest position.
2. Connect the battery to the KODO
FPV and place it on a level surface.
Listen for two beeps. The red LED at
the back of the quadcopter will start
fl ashing slowly.
3. Move the throttle to its highest position. Listen for a beep.
4. Move the throttle back to its lowest position. Listen for three
beeps.
™
USB
Charger
Screwdriver
change the sensitivity
of the controls.
x2
Moderate
x3
Maximum