Advertisement
Quick Links
Advertisement
Summary of Contents for ROOFLIGHT COMPANY neo Steel
- Page 1 neo™ Steel Multistop Roller Blind Installation Manual Issue 01 | January 2014 NSBL-MR-001INST-A...
- Page 2 Multistop Roller Blind Installation Manual Thank you for purchasing neo™ Steel Multistop Roller Blind, please follow this step-by-step guide to ensure the blind is installed correctly. If the rooflight’s integral linings have not been factory painted, we recommend painting them before the blind is installed. This blind system requires a reasonable level of practical skill to ensure correct installation.
- Page 3 Multistop Roller Blind Installation Manual Step 1.0 Using the orientation shown on the drilling template (provided on inside of back page), drill through Hole A on the template. Note: Do not drill deeper than 10mm through the integral lining. Please note: these images do not show a complete roof window installation with painted linings and internal finishes.
- Page 4 Multistop Roller Blind Installation Manual Step 2.0 Using one of the screws (Part B), screw in the left blind channel (Part C) at the cill only. Please note: these images do not show a complete roof window installation with painted linings and internal finishes.
- Page 5 Multistop Roller Blind Installation Manual Step 3.0 Let the two blind channels (Parts C and D) angle down into the room, Locate the roller blind (Part E) into the ends of the channels (see arrows). Please note: these images do not show a complete roof window installation with painted linings and internal finishes.
- Page 6 Multistop Roller Blind Installation Manual Step 3.2 The black friction sliders on each end of the hem bar need to be located into the upper section of the channel on both sides (see arrow). Please note: these images do not show a complete roof window installation with painted linings and internal finishes.
- Page 7 Multistop Roller Blind Installation Manual Step 4.0 Drill the remaining holes in the roller blind channels. Repeat on the other side. Note: Do not drill deeper than 10mm through the integral lining. Please note: these images do not show a complete roof window installation with painted linings and internal finishes.
-
Page 8: Installation Complete
Multistop Roller Blind Installation Manual Step 5.0 Check the operation of the blind by tilting the handles towards the ironmongery and sliding the blind up and down the rooflight. To lock the blind, tilt the handles away from the ironmongery. Please note: these images do not show a complete roof window installation with painted linings and internal finishes. - Page 9 Multistop Roller Blind Installation Manual Issue 01 | January 2014...
- Page 10 Multistop Roller Blind Installation Manual Issue 01 | January 2014...
-
Page 11: Drilling Template
DRILLING TE Multistop Roller Blind Installation Manual DRILLING TEMPLATE 2 HOLE (7/64” /2.8mm HOLE B (7/64” /2.8mm Drill bit) Part A: Drilling Template Align arrows to the bottom edge Centre l Carefully push the drilling template below out of the Align arrows to the bottom edge of rooflight intergral lining manual cover and use as instructed in the manual. - Page 12 Designed in the U.K Assembled in the U.K. Wychwood Business Centre Milton Road Shipton-under-Wychwood OX7 6XU Tel: 01993 833108 Fax: 01993 831066 Email: info@therooflightcompany.co.uk www.therooflightcompany.co.uk BS EN 1279-2 BS EN 1279-3 In the interest of continuous product development, it may be necessary to amend specification without alteration to technical literature. All drawings and designs are the Copyright and Design right of The Metal Window Company Ltd.
Need help?
Do you have a question about the neo Steel and is the answer not in the manual?
Questions and answers