SLX 27887K4 User Manual

27887K4
Congratulations on the purchase of your high gain wideband aerial kit. This aerial has been manufactured to the standard required to get
the best reception of digital terrestrial TV services. Check before installation at www.dtg.org.uk/industry/coverage.html to find where your
local transmitter is. This kit contains all the items necessary for mounting the aerial to an existing mast or for mounting externally to
eaves or a wall or mounting in a loft. This kit also contains 10m of digital type coax cable to ensure good reception.
This aerial is also 4G ready - the design restricts bandwidth to prevent interference & channel loss on your TV caused by signals from 4G transmitters.
As every aerial installation is different in nature, the fixings (pole mount and pole) supplied with this
WARNING
aerial kit are suitable for loft mounting only. If you plan to mount this aerial in an outside location use
either an existing fixing bracket and mast or buy a suitable bracket and mast from your local DIY store.

Main Features

•
Wideband – suitable for all UK TV reception areas, covering
frequency range 460-790MHz
•
Receives digital TV signals
•
Suited for moderate and strong signal strength areas
The aerial requires some assembly - please read these
instructions carefully before beginning.

A. Fitting the dipole assembly

The dipole clips onto the central boom. Ensure that the cable
exit hole (from the terminal box) faces the rear of the aerial
and that the locating stud fits into the locating hole on the
boom as shown in Fig. 1.
B. Rotating aerial elements and central
boom assembly
1. Rotate the elements about the central fixing clip until
they 'snap' into an upright position as shown in Fig. 2.
2. The central boom comes in two sections using the
bracket supplied and the holes drilled in the boom
sections join these two sections as shown in Fig. 3.
Fig. 3
1st 2nd
Element Element
Back of
aerial

C. Fitting the reflectors

1. Using the reflector clamps, screw and large wing nut,
fix the reflector assemblies to the main aerial boom as
shown in Fig. 4 and 5.
2. Check that the reflector clamp tabs locate in the holes
of the reflector boom sections and that the wing nut
is tight, see Fig. 5.
3. Ensure that the reflector elements are facing towards the
front of the aerial (convex surface forward).
32 Element Digital TV Aerial Kit
USER GUIDE
3rd 4th
Element Element
Fig. 4
Fig. 1
rear of aerial
central boom
locating
hole
Fig. 2
rotate
elements
engage
tab
in hole
Ready
dipole
locating stud
element
in upright
position
reflector boom
assembly reflector
clamps
reflector
element
Fig. 5