Advertisement
THiS ASSEMBLY
iS FOR 917TRACTOR
MODELS
ONLY.
IFYOUR TRACTOR LOOKS LIKE FIGURE 1A
•
install two 3/8" x 1-1/4" hex bolts in the left side of the
tractor as shown. Attach the Left Mounting Bracket
(pin at top facing in) to the bolts using two 3/8" lock
washers and 3/8" hex nuts. Repeat on the right side.
3/8" × 1=1/4"
HEX
BOLT
0
0
0
0
FIGURE 1A
RIGHT MOUNTING
BRACKET
LEFT MOUNTING
BRACKET
3/8" LOCK WASHER
HEX NUT
IFYOUR TRACTOR LOOKS LiKE FIGURE 1B
Remove the nuts from the two bolts shown in each
side of the tractor, leaving the bolts in place.
•
Attach the Left Mounting Bracket (pin at top facing
in) to the bolts using the original nuts and a 3/8" fiat
washer. Repeat for the other side.
NOTE: if no bolt and nut are present in a hole, use a
3/8" x 1-1/4" hex bolt, 3/8" lock washer and 3/8" hex nut to
attach the Mounting Bracket to the hole.
RIGHT MOUNTING
BRACKET
STEP 1:
(SEE FIGURE 2)
Hook the Sleeve Hitch Frame assembly onto the weld
pins. Attach the bottom of the assembly to the tractor
hitch using a 5/8" x 1-3/4" hex bolt and a 5/8" nylock
nut.
NOTE: if your tractor hitch has ridges that prevent the
sleeve hitch assembly from resting fiat, place the spacer
plate underneath the sleeve hitch assembly.
STEP 2:
(SEE FIGURE 2)
Proceed to LIFT ASSEMBLY instructions on page 8.
SLEEVE HITCH
FRAME ASSEMBLY
LIFT LEVER
ASSEMBLY
WELD
PiN
FIGURE 2
FIGURE 1B
6
LEFT
MOUNTING
BRACKET
LOCK WASHER
(if new bolt and nut are needed)
ORIGINAL
NUT
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
