Connection Via The Web Browser - Bosch FLEXIDOME IP starlight 8000i Installation Manual

FLEXIDOME IP starlight 8000i
6

Connection via the web browser

The unit must have a valid IP address and a compatible subnet mask to operate on your
network. By default, DHCP is pre-set at the factory to On and so your DHCP server assigns an
IP address. With no DHCP server the default address is 192.168.0.1
To view the camera in your web browser:
1.
2.
3.
Note:
To see live images in your browser it might be necessary to download and install the MPEG-
ActiveX from the Bosch download store.
Protected Network
If a RADIUS server is used for network access control (802.1x authentication), the unit must
be configured first. To configure the unit, connect it directly to a computer using a network
cable and configure the two parameters, Identity and Password. Only after these have been
configured can communication with the unit via the network occur.
IP Helper tool
Alternatively, use the IP Helper tool to detect Bosch devices on the network:
1.
2.
3.
4.
Bosch Security Systems
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions that appear.
Access the Bosch download store (http://downloadstore.boschsecurity.com/).
Download and install IP Helper.
Choose your specific camera from the list of cameras shown in the table on the left of the
screen
Click Open in browser to view the camera interface.
Installation Manual
Connection via the web browser | en 31
2018.11 | 01 |