Table of Contents
Advertisement
TOOLS REQUIRED FOR ASSEMBLY
(1)
Standard Screwdriver
(2)
15/16" Wrenches (one should be box-end)
(2)
3/4" Wrenches
(2)
9/16" Wrenches
(2)
1/2" Wrenches
(2)
7/16" Wrenches
(1)
3/8" Wrench
ADDITIONAL ITEMS NEEDED
Ruler or Tape Measure
Grease
REMOVE PARTS FROM CARTON
• Remove the hardware pack and all loose parts from
the carton.
• Lay cardboard on floor to help prevent scratching of
painted parts.
• Lay out and identify all the parts and hardware as
shown on pages 4 through 6.
ASSEMBLE SCOOP
STEP 1: INSTALL TWO BOLTS
(SEE FIGURE 1)
• Assemble two 3/8" x 1-1/4" hex bolts (D) and 3/8" hex
nuts (Q), threading the nut all the way onto the bolt
until it is tight against the head of the bolt.
• Install a nut/bolt assembly into the bucket assembly
and fasten using a 3/8" nylock nut (R). Tighten.
Repeat for the other side.
STEP 2: INSTALL PIN STOP BRACKET
(SEE FIGURE 1)
• Install the pin stop bracket to the top of the bucket
assembly using four 5/16" x 1" hex bolts (F), eight
5/16" washers (EE) and four 5/16" nylock nuts (T).
Leave the bolts loose enough that the position of the
pin stop bracket can be adjusted later.
ASSEMBLY
5/16" WASHERS (EE)
5/16"
NYLOCK
NUT (T)
3/8" NYLOCK NUT (R)
FIGURE 1
STEP 3: INSTALL LIFT FRAME ASSEMBLY
(SEE FIGURE 2)
• Apply grease to the mounting surface of the bucket
assembly and the inside of the lift frame arms.
• Assemble the lift frame assembly to the bucket
assembly using two 5/8" x 1-1/2" hex bolts (A) and
5/8" nylock nuts (M). Tighten, then loosen the nuts
1/4 turn, or until the lift frame pivots freely.
5/8" x 1-1/2"
HEX BO L T (A)
APP L Y
GREASE
5/8" NYLOCK
NUTS (M)
FIGURE 2
7
5/16" x 1"
HEX BO L T (F)
PIN S T O P
BR A CKE T
B UCKE T
ASSEMB L Y
3/8" x 1-1/4"
HEX BO L T (D)
3/8" HEX NUT (Q)
APP L Y
LIFT FRAME
GREASE
ASSEMB L Y
5/8" x 1-1/2"
HEX BOLT (A)
APP L Y GREAS E
Advertisement
Table of Contents
