Cree Edge Series Installation Instructions

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. To avoid the possibility of electrical shock, turn off power supply before
installation or servicing.
2. Product must be installed in accordance with NEC or your local
electrical code. If you are not familiar with these codes and
requirements, consult a qualified electrician.
3. Ensure the mounting surface is capable of supporting the weight of the
luminaire after installation.
4. Due to the weight of the luminaire, 3 people may be necessary during
installation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Note: Pendant and hooks are only supplied with luminaire when ordered as
"Pendant" or "Hook and Cord" mounting.
TO INSTALL:
1
Mounting Bracket
Bolts (4)
MOUNTING - TRANSPORTATION/DIRECT MOUNT
STEP 1:
Remove the (4) nuts and washers securing the retained
Mounting Bracket Bolts to the top of the mounting bracket.
Remove the top piece of the mounting bracket assembly
from the luminaire. See Figure 1.
STEP 2:
Align the mounting bracket removed in Step 1 on an
appropriate mounting surface. Using customer supplied 3/8"
minimum mounting bolts, secure the bracket to the mounting
surface. See Figure 2.
STEP 3:
Once the mounting bracket is secured to the mounting
surface, re-secure the luminaire using the nuts and washers
removed in Step 1.
STEP 4:
Install a suitable Listed cord strain relief brushing or
bushing in the customer supplied junction box, and feed the
luminaire's cord through it.
1 of 2
2
Mounting Holes For Customer
Supplied 3/8" Mounting Bolts
STEP 5:
Connect the cord to the supply wiring per the Electrical
Connections section.
MOUNTING - PENDANT MOUNT
STEP 1:
Install the pendant fitter using (4) supplied screws to the top
of the mounting bracket. See Figure 3.
STEP 2:
The pendant can be adjusted laterally by the pendant fitter to
the desired position and then tightening the (4) Adjustment
Screws. See Figure 3.
STEP 3:
Size the customer supplied pendant accordingly and
ensure that the pendant and mounting surface is capable of
supporting the weight of the luminaire.
STEP 4:
Attach the Mounting Bracket to the customer supplied
pendant and pendant coupling. Secure the pendant fitter to
the pendant coupling.
LED High-Output High Bay Luminaire
Transportation, Direct, Pendant, Hook and Cord Mounts
INSTALLATION INSTRUCTIONS
3
Cree Edge™
Adjustment
Screws (4)
Pendant Fitter
LPN00102X0001A0