Page 5
It is important to try the different features of this phone thoroughly and in different locations, using your hearing aid or cochlear implant, to determine id you hear any interfering noise. Consult your carrier or Unitech for information on hearing aid compatibility. If you have questions about return or exchange policies, consult your carrier or phone retailer.
Page 6
Canada. European Conformity Statement unitech Electronics co., Ltd herewith declares that the unitech product is in compliance with the essential requirements and all other provisions of the RED 2014/53/EU directive, the EMC 2014/30/EU directive and the Low Voltage 2014/35/EU directive.
Page 7
Waste electrical and electronic equipment (WEEE) unitech has set up a policy and process to meet the EU directive 2002/96/EC and update 2003/108/EC concerning electronic waste disposal.
Page 9
Laser Information The unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
Page 10
It may not be functional anymore. Please only use the original battery from unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by unitech’s warranty policy.
Page 12
Please remove the power adapter when the battery is fully recharged. The bundled power adapter that comes with your unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
Page 14
Worldwide Support unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan –...
Page 15
The warranty period is varied from each country. Please consult with your supplier or unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user.
PA730 User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the PA730 gift box. If something is missing or damaged, please contact your unitech representative. The standard package contents PA730 Terminal ...
Page 30
PA730 User’s Manual 1.4.5 Using The SD/SIM Card The PA730 has SD/SIM card slots inside the battery compartment. Inserting a SD/SIM card Remove the battery cover and battery pack. Insert the SD card to the left slot. Insert the SIM card to the right slot.
Android Beam option, make sure it is also turned on. 5. Make sure that the NFC area (shaded part) of PA730 and the other phone's NFC area are close to one another. Experiment by slightly moving the phones until a connection is made.
It only applies to the device which supports WWAN. 2. Turn on the terminal, 4G signal will show at the top of the screen. If you insert 3G SIM card into PA730, the icon is displayed on the status bar.
You can transfer your file from or to your computer. The OS of host side please use Windows 7 or upper. 1. Connect PA730 to your computer with the USB cable. Your computer will recognize it is USB charging. 2. Then slide from top, the system will show as follow picture, then you can select File transfers item.
Page 48
2.10.3 Photos & Videos Storage Location You can choose two different storage ways to save photos & videos : Phone or SD card. SD Card item can not be activated if no SD Card installed in PA730. Please see the photo below.
PA730 User’s Manual 2.13 Programmable Keys The PA730’s keys can be programmed for users to be able to perform different functions or applications. 2.13.1 Programming a Physical Key 1. Tap go to APPS, and tap Settings, go to SYSTEM, Tap Programmable keys 2.
Swap Mode. 2. The LED indicator will start showing solid red light. Please swap the battery after the LED red light goes off. Make sure do not turn on PA730 during the battery swap process. 3. When the battery swap is done, press the power button to restart PA730.
PA730 User’s Manual 3.6 MoboLink MoboLink is a software platform that helps unitech customers to remote manage their purchased devices and applications. The core of the MoboLink platform provides functionalities in the MDM (Mobile Device Management) and MAM (Mobile Application Management) domains, and then further extends into other management functions such as alert notification management and account management.
Need help?
Do you have a question about the PA730 and is the answer not in the manual?
Questions and answers