Advertisement
Quick Links
© Panduit Corp. 2014
FMD1
Contents:
1 - Enclosure
3 - #10 Flat Washers
10 - Pan-Ty Cable Ties
2 - Adhesive Mounts
2 - Bend Radias Brackets
(For part numbers FMD1 and FMD2 ONLY)
CAUTION:
Fiber optic cable is sensitive to excessive pulling, bending and crushing forces. Consult the manufacturer's cable specification sheet for
the specific cable in use.
Follow TIA/EIA 568-A, 569, 606, and 607 installation guidelines where applicable.
DANGER: UNMATED CONNECTORS MAY EMIT INVISIBLE LASER RADIATION. DO NOT LOOK DIRECTLY INTO THE END OF THE
CONNECTOR, DO NOT INSPECT WITH MAGNIFYING DEVICES. MAINTAIN CAP ON UNMATED CONNECTORS.
ASSEMBLY
(FMD2 shown)
Enclosure
Port identification label
For Technical Support: www.panduit.com/resources/install_maintain.asp
Opticom Drawers and Trays
Part Numbers: FMD1, FMD2, FMT1, FMT2
INSTALLATION INSTRUCTIONS
FMD2
4 - #12-24 x 1/2" screws
1 - #10-32 x 5/16" screw
4 - #10-32 Hex Nuts
1 - Strain Relief Bracket
1 - Port Identification Label
(For part numbers FMD1 and FMD2 ONLY)
Laser warning label
Caution label
Page 1 of 4
FMT1
1 - Caution Label
1 - Laser Warning Label
2 - Spools
1 - 24" Spiral Wrap
(For part numbers FMD1 and FMD2 ONLY)
Spool
Bend radius bracket
FS067
FMT2
#10-32 x 5/16" screw
Strain relief
bracket
Grommet
Advertisement
Related Manuals for Panduit FMD1
Summary of Contents for Panduit FMD1
- Page 1 4 - #10-32 Hex Nuts 1 - 24" Spiral Wrap 1 - Strain Relief Bracket 2 - Adhesive Mounts (For part numbers FMD1 and FMD2 ONLY) 2 - Bend Radias Brackets 1 - Port Identification Label (For part numbers FMD1 and FMD2 ONLY)
- Page 2 INSTALLATION INSTRUCTIONS FS067 © Panduit Corp. 2014 To engage the cover, slide forward until the cover slides under the front tabs then secure in place with #10-32 screw. Determine which grommet(s) will be used to bring the cable into the enclosure. Remove the knock-out at entry location of the fiber tray.
- Page 3 INSTALLATION INSTRUCTIONS FS067 © Panduit Corp. 2014 Secure the sliding tray with #10 washers and #10-32 hex nuts provided. Mount the enclosure to the rack using (4) #12-24 screws. To install the bend radius brackets, slide the bracket onto tab with the slot facing outside then snap in place.
- Page 4 INSTALLATION INSTRUCTIONS FS067 © Panduit Corp. 2014 Insert the panels into the enclosure as shown. Once mounted, push the latches in to secure the panel. Terminate the fibers with an appropriate connector. Mount each connector in the panel. Gently loop the excess fiber around the spools.
Need help?
Do you have a question about the FMD1 and is the answer not in the manual?
Questions and answers