Toro TouchNet 89-9150 Installation Instructions

Introduction
The Interface Cable Kit includes a special serial cable and a Hayes
Installation of the modem with the TouchNet central enables system communication via telephone line with compatibly-
equipped Network LTC Plus satellite controllers.
Note: While not a requirement for operation, a dedicated telephone line is recommended for this application.
Procedure
1. Place the On/Off switch of the TouchNet Central and data/fax modem in the Off position.
2. Connect the TouchNet to the modem using the interface serial cable supplied as shown in Figure 1.
3. Referring to Figure 1 and the instructions provided with the Hayes modem, install the remaining connections as shown.
Note: Setup software included with the modem is not required for installation or operation with the TouchNet Central.
Figure 1
Hayes Modem
On/Off
Switch
System Set Up and Test
1. Switch on the TouchNet Central and modem
2. Ensure COMMERCIAL mode is selected in the System Type
screen.
Note: The telephone communications option is not enabled
when the Golf system type is selected.
3. Ensure the modem-equipped Network LTC Plus satellite is
operational.
3. On the TouchNet Central, select SATELLITES from the Menu
screen.
4. Scroll to the address number of the telephone modem-
equipped satellite.
Note: Ensure the satellite is enabled for operation (represented by an "X" in the box adjacent to the satellite number). If
an "X" is not displayed, simply touch the box area to enable the satellite.
5. Select telephone communications for the satellite by touching the TELEPH box. A telephone number string (zeros) will
appear. See Figure 2.
6. Touch the telephone number string. A pop-up keypad will appear enabling the satellite modem telephone number to be
entered.
7. After entering the telephone number (a minimum of seven digits), return to the Menu screen and select UTILITIES.
8. On the utilities screen, touch "TELEPHONE" under Communications Setup. The Telephone setup screen will be dis-
played with the default setup parameters. You may find it necessary to change the default settings for your application.
Note: The default settings should be sufficient for most applications. For additional information regarding telephone
setup parameters, refer to telephone communications setup within the "Special Features" section of the TouchNet for
LTC Plus User's Guide.
TouchNet Central for Network LTC
TM
Telephone Modem Kit, Model No. 89-9150

Installation Instructions

Interface Cable
P/N 363-3612
To Telephone
(Optional)
To Modem
Power Supply Telephone Line
Accura 336 Fax Modem and power supply.
TM TM
On/Off
Switch
To TouchNet Central
(Back View)
Figure 2
Plus
TM
Touch screen here to
enter satellite modem
telephone number.