Bottom Terminal And Ets Magnets - Motion Control Engineering Motion 4000 Manual

Installation

Bottom Terminal and ETS Magnets

Magnets marked with a stripe to differentiate them from door zone magnets are used at the top
and bottom terminals for Motion 4000 installations. 5-inch striped magnets are also used for
physical ETS when required. If reduced stroke buffers are used, cam operated ETSL switches
may also be required.
Figure 2.21 Motion 4000 ONLY: Bottom Terminal and ETS
IF ETS
MAGNETS
USED
2 5/8" TO
TOP OF
DZ MAGNET
5 1/2" DZ
MAGNET
1. Place a 24-inch, striped magnet to the left of the tape perforations, just above the bot-
tom door zone magnet as shown above. The bottom of the 24-inch magnet must be even
with the top of the door zone magnet.
2. For jobs with rear doors only, stack two 5-inch striped magnets below the 24-inch mag-
net. Leave NO GAPS between the striped magnets.
3. For jobs with front or front and rear doors, stack one 5-inch striped magnet directly
below the Front Door Zone magnet. Leave no gaps between the ends of the magnets.
2-64 Manual # 42-02-2P24
Please refer to "LS-EDGE Steel Tape" on page 3-5.
FRONT
DOORS DOORS
5" STRIPED
ETS MAGNET
24" STRIPED
MAGNET
SCRIBE
5" STRIPED
MAGNET
5" STRIPED
MAGNET
BOTTOM TERMINAL
FRONT &
REAR REAR
DOORS
5" STRIPED
ETS MAGNET
24" STRIPED
MAGNET
SCRIBE
5" STRIPED
MAGNET
5" STRIPED
ETS MAGNET
24" STRIPED
MAGNET
5" STRIPED
MAGNET