Advertisement
4.6
referring to fig.6, insert the bent end of the control cable
through the hole at the bottom of the index plate lever and then
attach the index plate assembly to the right hand side of the
handle using an M6 x 30mm bolt (1) together with the
existing M6 lock nut (9) and wing nut (10) used to mount the
handle (18).
4.6.1 Attach the cable clamp mounting plate (17) to the connecting
tube just below the index plate assembly using one M6 x 30mm
bolt (1) with an M6 lock nut (9) as shown in fig.7. Lay the
control cable onto the mounting plate between the screw holes
and lay the cable clamp (20) over the cable and clamp it lightly
in place using two M5 x 10 screws (3) and two M5 locknuts (6).
4.6.2 referring to fig.9, push the index plate lever to the bottom of its
travel and make sure that the distribution slots on the
underside of the hopper are not covered by the rotating shutter.
now fully tighten the cable clamp.
4.6.3 test the action of the lever to ensure that the rotating shutter
successfully exposes and hides the distribution slots.
4.6.4 When the required distribution rate is achieved, the stop and
wing nut fitted in the lever slot can be brought up to the bottom
of the lever to fix its position. see fig.8.
fig.7
fig.8
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: no liability is accepted for incorrect use of this product.
wARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
5. OpERATION
5.1
5.2
5.3
6. MAINTENANCE
6.1
6.1.1 rinse/dry inside and outside of spreader after each use.
6.1.3 Periodically check all fastenings are tight.
6.1.4 Annually clean and lightly lubricate parts.
6.1.5 touch up all scratched or worn painted metal surfaces.
6.1.6 to avoid damaging the spreader never exceed the rated load
6.2
6.2.1 Before storing ensure that the spreader is clean and dry.
6.2.2 store indoors or in a protected area during severe weather and
6.2.3 never allow material to stay in the hopper for extended periods
sole UK distributor, sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
the spreader is designed to be pushed at three miles an hour,
which is a brisk walking pace. slower or faster speeds will
change the spread pattern. Wet fertiliser will also change the
spread pattern.
see figs.8 & 9 for suggested walking patterns depending on
the level of coverage you require.
clean the spreader thoroughly after each use
paying particular attention to the shut off plate and the bottom
of the hopper.
After each use clean material out of hopper.
capacity of 27kg.
sTORAGE.
in the winter months.
of time.
fig.9
fig.10
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
sPD27W
Issue: 1 - 13/06/11
Advertisement
