Assembly Instructions - Adventuridge 93410116 User Manual

IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE
TENT ONCE BEFORE GOING CAMPING TO BECOME
FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT
PARTS DIAGRAM TO SEE HOW YOUR FRAME IS
ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR,
SELECT A LEVEL, CLEAN AREA FOR THE CAMPSITE.
TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOORS TO ALLOW AIR TO ENTER THE TENT.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR
TENT, IT IS ADVISABLE TO USE SEAM SEALER TO
COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE INSIDE SEAMS OF THE TENT AND
UNDERSIDE OF THE TENT FLY. IF APPLIED TO THE
OUTSIDE OF SEAMS, DISCOLORATION OF YOUR
TENT MAY OCCUR. SEAM SEALER IS AVAILABLE IN
THE CAMPING SECTION OF ANY LOCAL SPORTING
GOODS STORE.
WARNING: During assembly of the main room and
side room tent pole, the tent poles are in tension. If the
poles are not held firmly in place by adults during assembly,
the tension in the poles may cause them to break or one end
of the pole to flip up, which could cause serious injury to you
or others involved in assembling the tent. To avoid this
hazard:
• DO HAVE two adults involved in assembling the tent.
• DO HAVE one adult hold the end of the tent pole in
place in the grommets at the crossed tent poles. When
the tent and poles are raised, the first adult who is at
the rear of the tent, goes to the front of the tent and
completes the pole connection into the grommets at the
front of the tent.
Failure to follow this warning could cause serious injury to
you or others involved in assembling this tent.
STEP 1: Spread tent out flat, floor side down.
STEP 2: Extend fiberglass tent poles by pulling out each section
and placing it into the metal ferrule connectors. You will have five
poles. The two longest poles (A) are the main tent poles. The next
pair of poles (B) will be used on the sides of the tent. The single
pole with pre-bent ferrules (C) will be used for the front awning on
the tent fly.
STEP 3: While making
sure sleeves are in line
with each other, slide the
main fiberglass tent poles
(A) through the sleeves
that are opposite each
other on the roof of the
tent. Straighten the
sleeves along the fiberglass sections. Position poles so that they
form an "X" across the tent.
STEP 4: Starting at the back of the tent,
place the ferrule at the end of the poles
onto the pins located on the rings at the
edge of the tent.
STEP 5: (Please read and follow IMPORTANT SAFETY
WARNING that appears before Step 1.) While one adult holds the
end of the tent pole firmly in place on the pin at the rear of the tent,
the other adult should now go into the front door of the tent
and gently lift the roof at the crossed tent poles off the
ground. When the tent and poles are raised, the first adult who is
at the rear of the tent, goes to the front of the tent, flexes the
fiberglass pole and places the metal ferrule at the end of the main
tent pole onto the pin located on the ring at the base of the tent.
Repeat step for the other main tent pole. Clip
plastic hooks to the fiberglass frame poles.
Locate the fabric ties
attached to the
center of the tent
roof and tie both
poles together.
STEP 6: Stake down tent by
inserting the steel stakes through
the metal rings and stake loops
attached at the base of the
tent. Hammer stakes into
ground at a 45° angle by
using a hammer or mallet.
Make sure to pull tent out even
and tight.

Assembly Instructions

A B B A
5