Table of Contents
Advertisement
Please follow the following steps one by one to install the PCI card successfully.
1. Power on your computer.
2. Be sure that there is no PCI card inserted yet.
3. Insert the Installation CD. Select the Software Installation from the menu and
click on Install.
4. Accept the license agreement.
5. Give the path of the destination folder. Click on NEXT.
6. Select the type of card as PCI card and click on NEXT.
7. Enter the ESSID default is ANY. You can change it later also using the
configuration utility or network configuration.
8. Select the network mode either Infrastructure or Ad-hoc and click on NEXT.
9. Confirms the current settings of ESS ID, Network Mode, and Utility directory.
Click on Next.
10. Click on Finish to complete the software installation.
11. Switch off your computer and insert the PCI card in the PCI slot.
12. Restart your computer and a message window pops up saying New Hardware
Found.
13. It takes a few seconds in setting up the driver for the new hardware i.e.
SAMSUNG PCI/PCMCIA Bridge and SAMSUNG 11 Mbps PCI WLAN
Card.
14. Check for the SAMSUNG 11Mbps Wireless PCI LAN Card by clicking on the
Device manager. If you find the Yellow sign on the adapter, it shows the
installation is not successful. Select the Adapter and click on Remove. Restart
your computer after uninstalling (See the Uninstallation method in section 3.4)
the driver. And refer the troubleshooting at the end of manual.
15. Right click on the Network Neighborhood using the mouse.
16. Select Properties from the pop up menu. The network box appears and you see
three main tabs: Configuration, Identification and Access Control.
17. Click on the configuration tab and then click on the add button. Select Network
Component Type box appears. Click on the Protocol then click the Add button.
18. Select Network Protocols box appears. From the list of manufactures, click on
Microsoft. From the list of network protocols list, select NetBEUI, then click
OK.
19. The NetBEUI protocol is now installed. After clicking on OK return back to
Network Component Type box.
20. Repeat the steps 17 and 18 to add IPX/SPX protocol.
21. Repeat the steps 17 and 18 to add TCP/IP protocol.
22. Select the TCP/IP option for setting the IP address of your computer. You can
13
Advertisement
Table of Contents
