Advertisement
Checklist:
You will need the following to perform the installation.
Drill with hammer function for masonry (with 5.5mm drill bit).
Screwdriver (Phillips)
Measuring tape
Marker (pencil)
Ruler (recommended)
Step ladder
Spirit level (recommended)
Hammer (not required but ideal)
Vacuum to clean dust from drilling
Note.
For wallboard or plaster: Use hollow wall anchors for added support (not supplied).
For concrete, stone, brick or tile: Use an appropriate drill bit (not supplied) and screws/plugs (provided).
For metal surfaces: Pre-drill holes before fastening the screws.
Parts
Facefix (Outside) Mounting Bracket
Hanging your blind:
Panel Blind Installation Guide
Pelmet Bracket
Recess (Inside Mounting Bracket)
Advertisement
Table of Contents
Related Manuals for Blinds Direct Classic Panel
Summary of Contents for Blinds Direct Classic Panel
- Page 1 Panel Blind Installation Guide Checklist: You will need the following to perform the installation. Drill with hammer function for masonry (with 5.5mm drill bit). Screwdriver (Phillips) Measuring tape Marker (pencil) Ruler (recommended) Step ladder ...
- Page 2 Step1. Before starting you need to decide if the blind is an Inside (Recess) or Outside (Facefix) blind installation. This will determine your blind position. Remember if Inside (Recess) you should ensure the blinds will not be obstructed but obstructions like window handles or burglar bars for example.
- Page 3 Step 4. Remove the Panels from their packaging. Then mount each panel onto the Velcro strip on top of the headrail. Step 5. This applies to the Facefix Panel Blind. Once all the panels are in position. Attach the Pelmet Bracket to the Pelmet. ...
Need help?
Do you have a question about the Classic Panel and is the answer not in the manual?
Questions and answers