Data Vox Settings; Other Settings For The Data Vox; Allocating The Data Send Function To The Pf Keys; Setting The Transmission Method For Audio Input To The Rear Terminal - Kenwood TS-990S Setting Manual

4.1.4 DATA VOX Settings

If you use the VOX function keyed by the sound from the USB audio input, select "USB
Audio" as the audio source for DATA VOX. (Refer to the chapter entitled "SELECTING
OR DISABLING THE AUDIO SOURCE FOR DATA VOX", in the user manual.)
Caution:

When this function is ON, all sounds created by the computer are transmitted
along with the intended audio transmissions.

When using this function for the first time, we recommend connecting a dummy
load to the TS-990S to perform checks and adjustments.

4.1.5 Other settings for the DATA VOX

If necessary, adjust the following settings for the DATA VOX.

VOX gain for USB audio input

ANTI VOX level for USB audio input

VOX delay time for USB audio input
(Refer to the chapters entitled "ADJUSTING THE VOX GAIN", "ADJUSTING THE
VOX DELAY TIME" and "ADJUSTING THE ANTI VOX GAIN LEVEL", in the user
manual.)

4.1.6 Allocating the DATA SEND Function to the PF Keys

Set the DATA SEND function to the PF keys to test the transmission of audio input
from the rear terminal. In this example, the [PF A] key has been set.
Menu No.
0-15
Using the [PF] keys to which the DATA SEND function has been set, you can switch
between transmit and receive mode for audio input from the rear terminal.

4.2 Setting the Transmission Method for Audio Input to the Rear Terminal

The [SEND] keys on the PTT switch of the microphone connected to the TS-990S and
on the TS-990S control panel are the method for transmitting audio input to the
microphone connected to the TS-990S. When transmitting by these methods, audio
entered as audio signals from USB cannot be transmitted.
To transmit audio input as audio signals from the USB, select one of the following
methods.
●
Transmitting using the ARCP-990
With the ARCP-990, you must perform settings to transmit audio input through the
rear terminal to use the on-screen [Send] key.
Function
Assignment of the programmable function
to [PF A]
7
Set value
DATA SEND