Silverlit OP ONE Instructions

OP ONE
HUMANOID RC BOT
INSTRUCTIONS
CONTENTS
A B
O.P. One Remote Controller
Robot
BATTERIES:
The robot requires 6 "AA" 1.5V alkaline batteries (not included).
The remote control requires 3 "AA" 1.5V alkaline batteries (not included).
You will need to use a Phillips or Cross screwdriver to open the battery compartments.

REMOTE CONTROL:

• Open the battery compartment.
• Insert the batteries according to the diagram inside the battery tray.
• Replace battery cover and tighten screw.
ROBOT:
• The battery compartment is between the wheels.
• Loosen the screw to remove the battery cover.
• Remove battery pack and install the "AA" 1.5V
alkaline batteries according to the diagram inside
the battery pack.
• Replace battery pack. Orient the pack so that the
cables are not pinched or twisted. There is a
pocket for the cable to fit into.
• Replace battery cover and tighten screw.
STATUS LED's
GREEN - NORMAL MODE
RED - VOICE MODE
DIRECTIONAL HEAD
JOYSTICK MOVEMENT
LEFT ARM
MOVEMENT
VOICE MODULATOR MICROPHONE
(5 settings) (closed position)
MICROPHONE
(open position)
POWER SWITCH
(off/auto/manual)
PROGRAM
START/SAVE
PLAYBACK/
CONFIRM PROGRAM
PROGRAM
MODEL NUMBER: 1005226
CABLE
POCKET
FRONT OF ROBOT
LED Eyes
Microphone
DANCE MODE
RECORD
Speaker
RECORDING
PLAYBACK
LISTEN
SELECTOR
SWITCH
Thank you for your purchase of Op One
Bot. Please read all instructions and
warnings on this sheet prior to using the
Op One Bot. Keep this instruction sheet as
it contains important information for future
reference.
SAFETY WARNINGS: PLEASE READ BEFORE USE
• Avoid water when operating.
• Adult supervision required.
• Indoor use only.
• Do not submerge robot or controller in water.
• Do not use people or animals as obstacles.
• Do not run robot into furniture objects or hard surfaces as
• Keep fingers, hair and loose clothing away from the tires,
• Do not leave robot or transmitter near sources of heat or
• Remove all batteries when not in use to avoid accidental
operation.
• Adult supervision is recommended when operating robot.
• Thoroughly inspect products before every use. If the
• Keep these instructions for future reference.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
batteries.
• Alkaline batteries are recommended. Use only the specified
voltage.
• Insert batteries using the correct polarity. Always use,
replace, and recharge (if applicable) batteries under adult
BATTERY COMPARTMENT
supervision.
• Do not charge with non-rechargeable batteries.
• Do not short-circuit the battery supply terminals.
• Do not dispose of batteries in a fire, batteries may explode
or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state,
and local laws.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
BATTERY COMPARTMENT
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
Head Microphones LR
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Demo
—Consult the dealer or an experienced radio/TV technician
for help.
Designed and manufactured by Silverlit Toys Manufactory Ltd.
Sharper Image® name and logo are registered trademarks.
Distributed by and © 2018 MerchSource, LLC. Irvine, CA 92618.
For technical support, please call 1-800-374-2744.
The artwork and design of this manual are proted by US
copyright law and may not be produced, distributed, displaced,
published or used for any purpose without prior written
permission. Altering, removing or reproducing any of the
On/Off
(On Back)
trademark or copyright notice forms on this manual is not
permitted.
Printed in China
AGES 6+
SAFETY WARNINGS
his will cause damage to both the objects and robot.
gears and motor while robot is switched to "ON'.
under direct sunlight for long periods of time.
product appears worn, frayed/splintered, cracked, or
broken in any manner, discontinue use and discard
immediately.
BATTERY WARNING