Cleaning The Filters - Shark Lift-Away NV601UK Series Instructions Manual

STEP 3
3 Press top dust-cup
release latch to access
dust screen and remove
built-up debris as required.
PRE-MOTOR
Foam filter
Filter frame
Felt filter
POST-MOTOR

CLEANING THE FILTERS

1 Pre-Motor
(foam and felt):
With the dust cup
removed, take out the
foam and felt filters, and
rinse with water. Tap loose
dirt off filters between
washes as needed.
2 Post-Motor (HEPA):
To access the HEPA filter,
reach under the grill, pull
the latch forward, and
pull the grill away from
the vacuum.
NOTE: To remove the
pre-HEPA filter frame,
pull on either of the bars
indicated by the arrows.
Remove the filter
assembly, then remove
the black foam filter and
plastic frame from the
assembly. Rinse both
HEPA filter and black
foam filter and allow to
air dry completely before
replacing. To assemble,
place the foam onto the
HEPA then place the
frame on top.
Hand wash only.
s h a r kc l e a n . e u
18