Pre-Installation Information - Philips LED4 Manual

previously installed bulb has sufficiently cooled. Contact may result in severe
burns or burning of cables surrounding the bulb.
• Do not expose the surface of the LED bulb to dust or oils, or cause the surface
to bear shock or otherwise become damaged.
• Keep out of reach of children.
Other Issues
m
• Please ensure that the product comes from a legal sales channel.
• After installation, check that the high and low beams, the flash function, and other
electrical equipment on the dashboard work and that no warnings occur.
• After installation, ensure that the waterproof gasket is fitted correctly to reduce
the risk of leakage.
• Do not put the driver box below or under the heating or moving components
inside the engine compartment. This will cause the driver to overheat and cause
the LED to not function.
• Do not tie cables to hot or moving components.
• Please ensure that the driver box and cables do not interfere with other compo-
nents or the engine hood.
• Do not bend the cables excessively, especially near the driver or heat sink area.

Pre-installation Information

• Ensure that there is at least 70mm of space behind the headlight fixture and that
the fixture has a diameter of 60mm as shown in Figure 1.
• Ensure that the light fixture has a gasket seal and a metal spring or similar attach-
ment mechanism. Use the metal spring to attach the bulb as shown in Figure 2.
4
Figure -1
Figure -2
Ф60mm