Table of Contents
Advertisement
WE RECOMMEND quality parts and lubricants, available at your Authorized Service Center.
PART NUMBERS MAY CHANGE, use part numbers listed below when you order. If a number
changes, your dealer will have the latest number.
WHEN YOU ORDER PARTS, your Authorized Service Center needs your machine serial number and
engine serial number. These are the numbers that you have recorded on the inside front cover of this
manual.
ALL PART NUMBERS shown are available through your Authorized Service Center.
Parts for Tractor and Mower Deck
Air Cleaner Elements (Model S2048):
Foam Precleaner
Paper Element
Air Cleaner Elements (Model S2554):
Foam Precleaner
Paper Element
Fuel Filter
Oil Filter
Battery
Spark Plug
Fuse-15 amp
Headlight Bulb
Belts (48-Inch Mower):
Primary (PTO clutch to upper deck sheave)
Secondary (Lower deck sheave to blade spindles
Belts (54-Inch Mower):
Primary (PTO clutch to upper deck sheave)
Secondary (Lower deck sheave to blade spindles
Blade (48-Inch Mower)
Blade (54-Inch Mower)
Leveling Gauge
(Part numbers are subject to change without notice. Part Numbers may be different outside the U.S.A.)
If you would like a copy of the Parts Catalog for this machine, please use the Order Form in the
SERVICE LITERATURE section.
REPLACEMENT PARTS
ITEM
Replacement Parts - Page 32
PART NUMBER
M133094
(Kohler #24 083 01)
M133095
(Kohler #47 083 03)
M133094
(Kohler #24 083 01)
M133095
(Kohler #47 083 03)
M132403
AM125424
(Kohler #12 050 01)
TY21752
Champion – RC12YC
(Kohler #12 132 02)
99M7065
AD2062R
(GE #1156)
M131237
M110318
M131237
M118685
M115495
M115496
TY15272
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the S2048, S2554 and is the answer not in the manual?
Questions and answers
how to go about leveling mover deck
To level the mower deck on Scotts S2048 and S2554, follow these steps:
1. Park the Tractor: Ensure it is on a hard, level surface.
2. Stop the Engine: Turn off the engine and remove the key.
3. Check Tire Pressure: Ensure tire pressures are correct.
4. Set Cutting Height: Adjust the cutting height to 50 mm (2 in).
5. Lower the Mower Deck: Move the lift lever to the MOWING (lower) position.
6. Check Blade Alignment: Rotate the left blade by hand until it is parallel to the tractor axle. Hold the drive belt and turn the right blade parallel.
7. Adjust Gage Wheels: Ensure the gage wheels do not contact the ground. Adjust if necessary.
8. Use a Deck Leveling Gauge (Optional): A deck leveling gauge (Part Number TY15272) can be used for accuracy, available from an authorized service center.
Always wear gloves when handling mower blades to avoid injury.
This answer is automatically generated
How do you get the mower in reverse