Table of Contents
Advertisement
Installation Instructions
Tuson Sway Control
TSC-1000
US PAT. NO. 9,026,311 / 9,415,753
AUS PAT. NO. 2014204434 / 2016204948
TUSON
TUSON
Tuson RV Brakes, LLC
Tuson Australia PTY LTD
475 Bunker Court
150 Northbourne Road
Vernon Hills, IL 60061 USA
Campbellfield, VIC 3061 Australia
800-968-8766
+61 3 9305 3484
www.tusonrvbrakes.com
www.tusonaustralia.com.au
November 2018
Advertisement
Table of Contents
Summary of Contents for Tuson TSC-1000
- Page 1 Tuson Sway Control TSC-1000 US PAT. NO. 9,026,311 / 9,415,753 AUS PAT. NO. 2014204434 / 2016204948 TUSON TUSON Tuson RV Brakes, LLC Tuson Australia PTY LTD 475 Bunker Court 150 Northbourne Road Vernon Hills, IL 60061 USA Campbellfield, VIC 3061 Australia...
-
Page 2: Installation Instructions
Warning! Designed and Engineered in the USA by Tuson RV Brakes, LLC sway control module. Mount this edge parallel with the trailer axle beams approx, 1 to 10 feet back from trailer bumper hitch ball ON A VERTICAL FRAME SURFACE 1.1 Mounting Hardware:... - Page 3 1 to10 feet Full Size +12V behind hitch Trailer Battery ball TSC mounted with the correct Frame side in the Ground UP direction Tuson Sway TSC Center on Control Vertical Frame Surface on Trailer Edge Parallel Centerline with Axle Beams Trailer Centerline...
-
Page 4: Section Two: Tsc Wiring
Full Size +12V Full Size +12V Trailer Battery Trailer Battery Frame Frame Ground Ground All Grounds Connected Must Use Together Tuson Tuson Full Size Sway Control Sway Control Trailer Battery Left Front Right Front Left Front Right Front Driver’s Side Curb Side Driver’s Side... - Page 5 Brake Trailer Battery Trailer Battery “Hot” Wire Signal Wire Frame Frame Ground Ground Break-Away Switch “Cold” Wire Tuson Tuson 12 Volt Sway Control Sway Control Connections Left Front Right Front Left Front Right Front Driver’s Side Curb Side Driver’s Side...
- Page 6 Section Two: TSC Wiring, continued Full Size +12V Trailer Battery Frame Ground Purple Wire Left (Driver’s) Tuson Side Brakes Sway Control Pink Wire Right (Curb) Side Brakes Right Front Left Front Curb Side Driver’s Side Electric Brake Electric Brake Left Rear Right Rear Driver’s Side...
- Page 7 Wiring Diagram BLACK GREEN +12 Volts Running Lights Bumper Pull Trailer 10 gauge 12 gauge Electric Drum Brakes with Tuson Sway Control BROWN Full Size +12V Left Turn - Stop Right Turn - Stop 12 gauge 12 gauge Trailer Battery WHITE...
- Page 8 Section Two: TSC Wiring, continued TSC Wiring Harness The TSC wire harness has five wires requiring electrical connection and one wire for the status LED light. The function of each of these wires is outlined in the table below: Wire Gauge Trailer Wire Function Wires Required...
-
Page 9: Section Three: Functional Test Procedure
Section Three: Functional Test Procedure Testing the TSC for correct wiring: In order to verify that the TSC is wired correctly, follow the test process listed below: WARNING!! IT IS VERY IMPORTANT THAT YOU FOLLOW THESE INSTRUCTIONS IN EXACT ORDER TO PREVENT DAMAGE TO THE TSC! 1) Ensure that the trailer battery is fully charged or that a charging device is connected to the trailer via the charge line and ground wire on the 7-way trailer connector. - Page 10 Section Three: Functional Test Procedure (cont.) FIGURE 1 FIGURE 2 3 RED 4 RED Flashes Flashes S t a t u s S ta t us L ig h t Li ght M o du l e Mo d ul e S tatu s S ta tus Light...
- Page 11 Section Three: Status Light and Troubleshooting Mount the Status Light Module in a location on the front of the trailer where the light is easily seen. GREEN, Flashing GREEN LIGHT ACTION CONDITION CORRECTIVE ACTION Statu s L ig h t Mo d ule Solid GREEN Normal operation - no system...
-
Page 12: Section Four: How The Tsc Works
This quickly dampens and brings operation of the sway control module. the trailer sway under control. Tuson Sway Control is based on the same technology used in automotive vehicle stability systems. Page 11... -
Page 13: Limited Warranty
PRIOR to processing any claim for warranty. Warranty claim must be received by Tuson within 30 days of the discovery of the alleged defect, or within 30 days of the expiration of the warranty, whichever is earlier. Covered repairs or replacements will be made at Tuson’s expense.
Need help?
Do you have a question about the TSC-1000 and is the answer not in the manual?
Questions and answers