Advertisement
Quick Links
Installation Instructions for the
ME Jr. plus 2 Alarm System
SK-800KME
ME Jr. plus 2 Alarm Module
Battery Installation:
1. Remove the screw that restricts the battery
door from opening using a phillips head
screwdriver as shown in Fig. 1.
2. Insert the key and turn it to the disarmed
position (the key cannot be removed in the
disarmed position).
Note: The battery door will not open without the
key in the lock and in the disarmed position.
3. Remove the battery door.
4. Before installing batteries, plug the (SK-195)
AC/DC Power Supply into the Alarm Module
jack marked Pwr. Input as shown in Fig. 2.
5. Install (4) fresh "C" Cell Alkaline batteries
following (+) and (-) polarity shown in Fig. 3.
VERY IMPORTANT! When installing batteries,
always follow the polarity indicated on the
battery holder.
6. Close the door as shown in Fig. 4. The horn
will "Double Chirp" until the door is securely
closed.
7. Replace the battery door retaining screw as
shown in Fig. 5. (If the key is in the disarmed
position for 1-1/2 minutes, the horn will
"Single Chirp" every 15 seconds to indicate
that the unit is in the disarmed mode.
ME Jr. Terminals
SK-80108ME
ME Jr. plus 2 (8) Port Strip
SK-3690
(Optional) "Where it's At Light"
Fig. 5
SK-800KME Series
SK-807ME
ME Jr. plus 2 (8) Port Splitter Box
Connects
Alarm Module
to Splitters &
Strips &
Splitters to
Splitters
SK-809
Telephone Modular
SK-847-x
"End Plug"
Extension
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Advertisement
Related Manuals for Se-Kure Controls SK-800KME Series
Summary of Contents for Se-Kure Controls SK-800KME Series
-
Page 1: Battery Installation
Installation Instructions for the ME Jr. plus 2 Alarm System SK-800KME Series ME Jr. Terminals SK-80108ME SK-807ME ME Jr. plus 2 (8) Port Strip ME Jr. plus 2 (8) Port Splitter Box Connects Alarm Module to Splitters & Strips &... - Page 2 Circuit “A” Light & AC Power Light Circuit “B” Light Will be lit when the SK-195 AC/DC Will be lit if a Termination Power Supply is supplying power to “End Plug” is not installed. the Alarm Center. Will )))flash((( if an alarm has been caused on that circuit.
- Page 3 The “Where It’s At” LED Light: All ME Jr. Splitter Boxes and Strips are equipped with a “Where It’s At” light jack, for this optional accessory. When an alarm occurs, the light will )))flash((( to alert associates of the location of the alarm. Plug them in wherever needed, and adhere the light where it can be seen from a distance, (usually...
- Page 4 4. Close the Alarm Module and the Infrared Remote Transmitter. Se-Kure Controls, ® Inc. On the Web: www.se-kure.com E-Mail: sekure@msn.com 3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999 Rev. 7/22/02 ©2002 Se-Kure Controls, ® Inc. SCI-9642...
Need help?
Do you have a question about the SK-800KME Series and is the answer not in the manual?
Questions and answers
The code we added to this machine no longer works. We cannot disarm machine.