Troubleshooting - Philips Lytemode 6-Button Remote Station User Manual

Troubleshooting

In order to determine if all Lytemode ILS Network devices are
communicating, a network test signal can be sent by placing the
device in the Addressing Mode. While in this mode, the device will
transmit a Network Test Command every 2 seconds (ON will
blink). All devices on the network will blink an LED to indicate
their reception of this command. If a receiving device matches the
transmitted ID, it will blink all of its LEDs. Those devices that are
capable of being polled will return a Network Test Response if the
transmitted ID matches their own ID. If the transmitting device sees
a Network Test Response, it will double blink its ON LED.
ON
A
B
C
D
OFF
ON
A
B
C
D
OFF
18
Factory Defaults and Troubleshooting
To send Network Test Command:
Step 1. Press and hold A and D for 3 or more
seconds. Network will send out test signal.
Step 2. Press ON to return to normal operation.