Sealey TC966 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instruction Protection
manual
1. SaFeTy
1.1. General safety
WarNiNG! ensure Health & safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment. under Health and safety law, employers and self employed Personnel have a legal duty to ensure safe Working
conditions for all employees and personnel that may come into contact with this equipment. in particular they must carry out a specific
risk and hazard assessment in the workplace to eliminate or reduce any risk found and must record, update and retain records of the
results of this inspection.
1.1.1. familiarise yourself with the applications, limitations and any possible or potential hazards of the Bead Breaker.
1.1.2. maintain the Bead Breaker in good condition (use an authorised service agent).
WarNiNG! check regularly for damaged parts. Any part that is damaged must be repaired or replaced before the equipment is
‰
next used.
1.1.3. use the Bead Breaker in a suitable work area, keep area clean and tidy and free from unrelated materials. ensure that there is
adequate lighting.
1.1.4. Keep the Bead Breaker clean for best and safest performance.
1.1.5. Wear approved safety eye protection.
1.1.6. Keep hands well clear of the bead breaker.
1.1.7. maintain correct balance and footing. ensure the floor is not slippery and wear non-slip safety shoes.
1.1.8. remove ill fitting clothing. remove ties, watches, rings other loose jewellery and contain and/or tie back long hair.
1.1.9. Keep hands away from pinch and crush points that can be created during operation.
1.1.10. Keep children and unauthorised persons away from the work area.
WarNiNG! dO NOT use on split, multi-piece or rims greater than 26".
‰
8 dO NOT use the Bead Breaker for any purpose other than that for which it is designed.
dO NOT operate the Bead Breaker if any parts are damaged or missing as this may cause failure and/or personal injury.
8
dO NOT allow untrained persons to operate the Bead Breaker.
8
dO NOT operate the Bead Breaker when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
dO NOT top up system with brake fluid. Use hydraulic oil only.
8
dO NOT adjust the safety overload valve.
8
WarNiNG! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. iNTrOducTiON
Hydraulic Bead Breaker, suitable for breaking beads on commercial and agricultural tyres. use in conjunction with hydraulic pump and hose
(not included).
© Jack sealey limited
instructions for
hydraulic bead breaker
model no:
Wear Protective Wear safety
Gloves footwear
Original Language Version
Tc966
tc966 | issue 2(i) 18/03/16