Page 2
WARNING! Electricity can kill. Normal operating voltage 230-240AC mains single phase 50HZ For the SOLiC 200 to qualify for the 10-year return-to- base warranty, please complete and return the enclosed postcard within 28 days, signed by a qualified electrician at the time of installation.
Page 3
To turn the immersion heater on manually – irrespective of whether solar power is being generated – press the boost button. The SOLiC 200 will offer full mains power to the immersion heater for 90 minutes. To manually resume automatic operation, press the boost button again during the 90 minutes.
Page 4
Turn off immersion circuit breaker on the consumer board Screw SOLiC 200 to wall ensuring a 3cm clearance around the unit Wire the SOLiC according to the wiring diagram inside the unit and arrange cables...
Page 5
Commissioning the SOLiC 200 Ensure the water in the immersion tank requires heating Ensure house is drawing at least 200W power Ensure that the immersion electrical circuit is Turn off the solar inverter and turn on immersion circuit breaker Allow 20 seconds for calibration: The Mains light should be green and Sensor light should be red.
Page 6
If there is a problem with the SOLiC 200, three red lights will show or only the Mains light will show or no lights will show. If three lights show, turn the power to the SOLiC 200 off , then verify the following: The sensor is connected to the correct conductor...
Page 8
Lights table Mai s Light Gree Po er is o The u it is i sta d y ode. Che k trou leshooi g suggesio s. Se sor light Gree Surplus po er is a aila le The house is dra i g grid po er Flashi g red/ ALL a aila le surplus po er is ei g gree...
Need help?
Do you have a question about the SOLiC 200 and is the answer not in the manual?
Questions and answers