Elecro Engineering 800 Series Installation Instructions & Operating Manual

O
PERATING
Once installation has been completed, run the water circulating pump for a few minutes to
purge the system of air.
On initial power up of the heater the amber light should illuminate. Only when the water cir-
culating pump is
operational and delivering in excess of 1,000-litres per hour of flow, and the temperature
knob is set to a value higher than that of the water temperature will the red indicator light
click on and the amber indicator light off. In this mode the heater is on and heating.
U
Remember to insulate and cover the water that is being heated wherever possible. This can
speed up the heating process and reduce running costs.
Water absorbs heat very slowly, which means it can take a few days just to raise the water
temperature by 15° at 1-kW per 1,000 gallons. This heat up time can be reduced dramati-
cally when care is given over to insulation.
GUARANTEE
Your ELECRO heater is guaranteed for one year from the date of purchase against faulty
workmanship and materials.
ELECRO ENGINEERING LTD will replace or repair, at it's discretion, any faulty units or
components returned to us for inspection.
ELECRO ENGINEERING LTD will not be liable in cases of incorrect installation of the
heater, or inappropriate use or neglect of the heater. Proof of purchase may be required.
ELECRO ENGINEERING LTD
Y E H
OUR LECRO EATER
T
SEFUL IPS
However:
Unit 14
Leyden Road
Stevenage
Herts.
SG1 2BW
Tel: 01438 749474
Fax: 01438 361329
www.elecro.co.uk
info@elecro.co.uk
800 Series Swimming Pool Heater
Installation Instructions
& Operating Manual
P R C
LEASE EAD AREFULLY
Incorrect Installation Will Effect Your Warranty
Do Not Discard, Keep For Future Reference
B I
EFORE NSTALLING