Advertisement
Quick Links
Trouble shooting
If you have a problem with your cleaner, consult the handy guide below. If the cleaner
is malfunctioning, do not operate it and please ask for service.
Problem
Possible cause
Cleaner won't run
1.Not firmly plugged in
Low suction
1.Clogged floor brush,
hose or tube
2.Full of dust in the dust cup
3.Dust cup not in place
4.Clogged the filter
Cord doesn't fully rewind
1.Cord twisted or uneven
Technical specification
-
Rating Voltage
230 240V
Rating Frequency
50Hz
Power Cord Length
4.5m
Possible solution
1.Plug unit in firmly
1.Remove the blockage
2.Empty the dust cup
3.Put the dust cap in place
4.Clean or replace the filter
1.Pull out the cord and rewind
1800-2000W
Power
Dust Capacity
1.5L
7
Instrcution Manual
Vacuum Cleaner
SC-X2015N
Advertisement
Related Manuals for Sanyo SC-X2015N
Summary of Contents for Sanyo SC-X2015N
- Page 1 Power Cord Length 4.5m Possible solution Instrcution Manual 1.Plug unit in firmly 1.Remove the blockage 2.Empty the dust cup Vacuum Cleaner 3.Put the dust cap in place 4.Clean or replace the filter 1.Pull out the cord and rewind 1800-2000W 1.5L SC-X2015N...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed including the following READ ALL INSTRUCTIONS PLEASE CAREFULLY BEFORE USING THIS APPLIANCE WARNING To reduce the risk of fire electric shock or injury Do not leave appliance when plugged in. Unplug from outlet when not in use. Do not use outdoors or on wet surfaces. -
Page 3: Save These Instructions
· If you find the motor temperature too high or any unusual noise when using, stop the operation and do not open the appliance. SAVE THESE INSTRUCTIONS This vacuum cleaner is intended for household use only. - Page 4 Name of parts M A X How to assemble/disassemble · To connect hose, press the button on the hose end and insert the hose into the opening until the hose locks. To detach, press the button ( ) on the hose end and pull the hose toward you.