Table of Contents
Advertisement
IS1580X15VSP Rev-A
PowerFlo VS
300
™
Owner's Manual
Model SP1580X15VSP
PowerFlo VS 300 Variable Speed Pump
Note: To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and
completely.
SAVE THIS INSTRUCTION MANUAL
Hayward Pool Products
620 Division St, Elizabeth, NJ 07207
Phone: (908) 355-7995
www.hayward.com
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Hayward PowerFlo VS 300
Summary of Contents for Hayward PowerFlo VS 300
- Page 1 IS1580X15VSP Rev-A PowerFlo VS ™ Owner’s Manual Model SP1580X15VSP PowerFlo VS 300 Variable Speed Pump Note: To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely. SAVE THIS INSTRUCTION MANUAL Hayward Pool Products 620 Division St, Elizabeth, NJ 07207 Phone: (908) 355-7995 www.hayward.com...
-
Page 2: Table Of Contents
Parts Listing Troubleshooting ............................16 8.1. General Problems Product Registration ............................. 18 Warranty ............................... 19 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 2 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... -
Page 3: Important Safety Instructions
– All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the National Electric Code (NEC). USE OF NON-HAYWARD REPLACEMENT PARTS VOIDS WARRANTY. ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, OPERATION, AND SAFE USE OF THIS VARIABLE SPEED PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT. - Page 4 Mechanical Entrapment - There is potential for jewelry, swimsuits, hair decorations, fingers, toes, or knuckles to be caught in an opening of a suction outlet cover resulting in mechanical entrapment. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 4 of 20...
-
Page 5: Save These Instructions
WARNING – Failure to install according to defined instructions may result in severe personal injury or death. SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 5 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... -
Page 6: General Information
2. General Information 2.1. Introduction This manual contains information for the proper installation and operation of the Hayward PowerFlo VS 300 Variable Speed Pump. The instructions in this manual MUST be followed precisely. 2.2. Primary Features Totally enclosed, permanent magnet motor ... -
Page 7: Installation And Wiring
Note: For FCC part 15 compliance, use flexible metallic conduit or a shielded power supply cable when installing this device. 3.1. Pump Location The PowerFlo VS 300 pump MUST be installed below the pool water line (see Figure to right). Install pump on a firm, level base or pad to meet all local and national codes. -
Page 8: Electrical
Pump MUST be permanently connected to circuit. If other lights or appliances are also on the same circuit, be sure to add their amp loads before calculating wire and circuit breaker sizes. Use the circuit breaker as the master On-Off switch. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 8 of 20 PowerFlo VS Variable Speed Pump... -
Page 9: User Interface Summary
The pump will automatically change from selected speed “3” to speed “1” after 2 hours of run time. The pump will automatically change from selected speed “2” to speed “1” after 24 hours of run time. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 9 of 20... -
Page 10: Display Power Saving Mode
To delete all error records, press the “ ” button for at least 3 seconds. Pressing the “SET” button or doing nothing within 30 seconds will exit the error code view mode. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 10 of 20 PowerFlo VS Variable Speed Pump... -
Page 11: Fault Error Code And Troubleshooting Chart
Keep motor clean. Insure motor air vents are free from obstruction to avoid damage. Do NOT use water to hose off motor. Occasionally, shaft seals must be replaced, due to wear or damage. Replace with genuine Hayward seal assembly kit. See “Shaft Seal Change Instructions” in this manual. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 12: Storage / Winterization
Disconnect all electrical power service to pump before beginning shaft seal replacement. Only qualified personnel should attempt rotary seal replacement. Contact your local authorized Hayward Dealer or service center if you have any questions. The National Electrical Code requires either a three (3) foot maximum twist-lock cord set with a GFCI protected receptacle or hard wire (conduit) connection for swimming pool pump installation. -
Page 13: Shaft Seal Change Procedure
16. Reconnect pump to the piping or hoses provided. Open all valves and make sure that the pump strainer housing is full of water before restarting the pump. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 13 of 20 PowerFlo VS Variable Speed Pump... -
Page 14: Replacement Parts
7. Replacement Parts 7.1. Parts Diagram Figure 7.1-1 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 14 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... -
Page 15: Parts Listing
Strainer Cover O-Ring SPX1500D2A Strainer Cover with O-Ring SP1516 Complete Strainer Assembly SPX1700FG Drain Plug with O-Ring SPX1515C C-Clip SPX1510Z1ECPMV Motor 1.0 HP, VS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 15 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... -
Page 16: Troubleshooting
All seal leaks should be replaced at once. 6. Equipment base vibrating. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 16 of 20 PowerFlo VS Variable Speed Pump... - Page 17 This page left blank intentionally USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 17 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A...
-
Page 18: Product Registration
INITIAL PRESSURE GAUGE READING (CLEAN FILTER) _______________________ PUMP MODEL __________________ *Retain this Warranty Certificate in a safe and convenient location for your records USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 18 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... -
Page 19: Warranty
10. Warranty USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 19 of 20 PowerFlo VS Variable Speed Pump IS1580X15VSP Rev-A... - Page 20 Other_____________________________ Model Number_____________________________________________________ Pool Capacity_______________(U.S. Gallons) New Installation Replacement Please include me on all e-mail communications regarding Hayward Equipment or promotions. Mail to: Hayward Pool Products, 620 Division Street, Elizabeth, NJ 07207 Installation for: Attn: Warranty Dept In Ground OR REGISTER YOUR WARRANTY ON-LINE AT WWW.HAYWARD.COM and PowerFlo VS are registered trademarks of Hayward Industries, Inc.
Need help?
Do you have a question about the PowerFlo VS 300 and is the answer not in the manual?
Questions and answers