Advertisement
Linebox NTE5C User instructions
Access to home wiring
connection point and
the network test
socket
Remove the front cover
by pressing the clips on
either side of the front
cover and gently pull the
plate forward.
do not need to remove the
coloured insulation from the wires
3. Thread the BLUE (or BLUE with
WHITE rings) in the right hand hole
above connector number 2. Make
sure the wire passes through the
front and rear holes.
4. Thread the BROWN (or ORANGE
with WHITE rings) in the centre hole
above connector number 3. Make
sure the wire passes through the
front and rear holes.
5. Thread the ORANGE (or WHITE
with BLUE rings) in the left hand
hole above connector number 5.
Make sure the wire passes through
the front and rear holes.
Older version of wiring colours are shown in
brackets above
In home wiring connection
1. Lift up the blue coloured
connection cover.
2. You will see 3 holes used
to separate and connect the
coloured wires for the home
wiring extension cable.
5 3 2
5 3 2
Advertisement
Table of Contents
Summary of Contents for Openreach NTE5C
- Page 1 Linebox NTE5C User instructions Access to home wiring In home wiring connection connection point and the network test 1. Lift up the blue coloured socket connection cover. Remove the front cover 2. You will see 3 holes used by pressing the clips on...
- Page 2 In home wiring connection 6. Push down the blue coloured connection cover and the home wiring will now be connected to the back plate. 7. If there is a spare GREEN (WHITE with ORANGE rings) coloured wire it can be trimmed back as it is not required.
- Page 3 NTE5C and close the red cover to make the connection. BT, Openreach, and the BT logo and the Openreach identity are trademarks of British Telecommunications plc. British Telecommunications plc Registered Office: 81 Newgate Street, London EC1A 7AJ Registered in England and Wales no.
Need help?
Do you have a question about the NTE5C and is the answer not in the manual?
Questions and answers