Summary of Contents for G-Lab PB-1
- Page 3 Dear Customer! Thank you for choosing our product. 8 SEPARETED 9V POWER BOX (PB-1) is eight outputs adapter to supply guitar effects with 9V direct current (DC). Each of eight outputs is full galvanic separated (isolated from input and others outputs). Separation...
- Page 4 Connecting to the effects Before connecting the PB-1 to the effect it is needed to: - check if the effect should be supplied with DC voltage. If so check if it is 9V - check if the effect features input power supply polarization CTR –...
- Page 5 If it the opposite connector polarity is required (CTR +) it is needed to use the output No. 4 (or 8) with changed polarity (diagrams on the box show location of the S4 (or S8) switch and polarity). ATTENTION: Damages caused by improper power supply causes the loss of the warranty.
- Page 6 Persons with qualifications and experiences in electrotechnics can prepare the cables shown below by themselves. The packet contains heat shrink tubes and labels for cables with descriptions. The diagram below shows the cable for the 9V effects with polarity CTR + (centre positive) (9V CTR - input, 9V CTR + output).
- Page 7 The diagram below shows the cable for supplying the effects requiring 18V DC with polarity CTR + (centre positive) (two 9V CTR - inputs, 18V CTR + output).
- Page 8 Using separated supply is the basic agent enabling to build the guitar systems without ground loops and supply crosstalk (the influence of variable load of one effect on the second). The best solution is to use separated supply of every effect. The exception from this is possible when the following conditions are met: - effects are placed in pedalboard or in other place fare from big mains transformers...
- Page 9 Linking wires without soldering The diagram below shows the way of linking two wires. The diagram below shows the way of linking three cables.
- Page 10 Mounting In case of mounting in pedalboard it is possible to use the Velcro fasteners provided with the adapter or to use M4 screw (adapter base posses bushings with M4 threads). The adapter can be also fastened to the rack 19’ systems by the use of 1U RMS Panel (product code 00829) and M3 screws supplied with the adapter.
- Page 13 ELZAB S.A., ul. Kruczkowskiego 39, 41-813 Zabrze, Poland, hereby declares on own responsibility that the following product: 8 SEPARETED 9V POWER BOX (G LAB PB-1) that is covered by this certificate and marked with CE 07 label conforms with following standards:...
- Page 14 DO NOT PLACE THIS PRODUCT INTO THE WASTE CONTAINER ! This device is marked with a cross-lined waste container symbol according to 2002/96/EU Directive on Waste Electric and Electronic Equipment. Such marking informs that after usage equipment can not be trashed together with other household waste.
Need help?
Do you have a question about the PB-1 and is the answer not in the manual?
Questions and answers