Attaching A Monitor Arm - Humanscale M/Connect 2 User Manual

ATTACHING A MONITOR ARM TO M/CONNECT 2
M2 / M 8 MONITOR A RM
Adjust Base Clamp for Correct Work Surface Depth
• Remove set screw (fig. J) from Base using hex key
• Insert Monitor Arm into the Base stem (fig. K) with its slot facing the rear
• Reinsert the set screw and tighten until it seats
and the 180º stop* is engaged
(*arm won't be able to swivel past the rear desk edge)
• Proceed to the "Attach VESA Bracket to Monitor" step
in the main M8 instruction guide
M / FL E X MONITOR A RM
Adjust Base Clamp for Correct Work Surface Depth
• Back out the two set screws installed in stem (fig. L)
• Insert M/Flex post (fig. M) into Base and twist onto internal bolt until fully seated
• Tighten both set screws evenly (fig. L) to secure post using hex key
L
K
J
M
9