Starting Engine - IHI 17VX3 Service Manual

OPERATION
STARTING ENGINE
Once the pre-start inspection has been completed, the engine may be started.
Starting at Normal Temperature
17VX3
If the engine does not start after 15 seconds, return the key
to OFF and wait for 15 seconds before returning it to
START.
1. Move Control shut-off lever to the LOCKED position.
2. Move all Controls to the HOLD position.
3. Move the engine throttle lever above the low to medium
position (advance about one-third to one-half).
4. Insert key
CD
into the switch and turn the switch to the ON
position.
5. Turn the switch to the START position.
Do not crank the engine for more than 15 seconds.
Allow the starter to cool for seconds before cranking again.
6. Release the switch key after the engine starts.
7. Move the engine throttle lever to position LOW to allow the
engine to warm.
Starting In Cold Weather
This engine has an inlet manifold heater for cold weather
starting. Do not use other types of starting aids such as
ether. Such use could result in an explosion and personal
injury.
1. Repeat steps 1 through 4 in Stating At Normal Temperature.
2. Hold the switch in the HEAT position to preheat the engine
intake air. After approximately 4 seconds the heater indicator
on the monitor will turn off.
This indicates that the engine is ready to start.
3. Repeat steps 5 through 7 in Stating At Normal Temperature.
3-3-1
Engine throttle lover
/
Stop Operation
(OFF) (ON)
Preheat
(HEAT)
Heater indicator