NSL Xenon Installation Instructions page 2

THROUGH-WIRE, 110V POWER
• Disconnect from all 110V power prior to installation.
• Connections must be made in accordance with all local
electric codes and/or NEC.
• Minimum 90˚C supply conductors.
• Interconnect up to 1188 Watts (66 bulbs).
• 14 gauge (Romex Type) or better wire is required.
• Requires strain reliefs.
• Use RTV silicone and water-tight fittings on all connec-
tions to fixtures.
12V
Transformer
Push-in
Connector
Incoming
110V
WARNING! If this fixture is to be placed in a masonry
or brick wall, you must use a Concrete Cap during can
installation to provide the proper void for the fixture
cover. Failure to use the Concrete Cap will almost
guarantee concrete or grout forming against fixture
can flange, and poor cover-to-can seal (see below).
Poor cover seal will allow water/moisture into fixture
resulting in LED and Xenon failure.
Without Concrete Cap With Concrete Cap
Cover
Cover
Poor
Proper
seal
seal
Concrete
or grout
Concrete or grout Concrete form used during
prevents cover from fixture can installation allows
allowing a proper seal for proper void and good
OTHER XENON PRODUCTS BY NSL
XENON TASK LIGHT
The perfect under-cabinet task light fixture. Brighter
than fluorescent, a fraction the heat of halogen, and
four times the bulb life of halogen.
XENON MINI LIGHT
A completely new design of the industry standard "hockey
Push-in
puck". A fraction the heat of a halogen, four times the bulb
Connector
life of halogen, similar bright white light.
Outgoing
XENON PICTURE LIGHT
110V
The new benchmark for picture lighting. No picture fading
UV's of halogen, greater light output, and four times the bulb
life of the competition.
XENON STEP LIGHT
Void created by
Concrete Cap
The brightest, longest-lasting 110V Step Light with aluminum
die cast construction in three cover designs and four colors.
Concrete
or grout
XENON BRICK LIGHT
Longest-lasting 110V Brick Light with aluminum die cast
brick-size construction in three cover designs and four colors.
cover-to-can seal
X
W
ALL
Damp Locations
Long-lasting Xenon technology
in a round die cast
aluminum fixture
Designed for Surface or Recessed Applications
10,000-hour bulb life
Louver, Scoop & Prism cover designs
White, Bronze, Black and Aluminum colors
Wet, IC, Ceiling
Die cast aluminum design
& Shower
Locations
suitable for concrete pour
UL Listed for wet locations
Wet & IC
Locations
9/08
I N S TA L L AT I O N
INSTRUCTIONS
ENON
L
IGHT
and IC Installations
110V Input
N S L
ATIONAL PECIALTY IGHTING
A D L
RCHITECTURAL AND ECORATIVE IGHTING
L C
OUISVILLE , O 80027
www.nslusa.com
Wet & IC
© 2008 National Specialty Lighting Locations